There are 2 options for device software configuration of your RPS-SP4L. You can download the RPS-SP4L-IPEDIT (click) program, or setup your computer on the same default IP Subnet as the RPS-SP4L, and access the unit directly by opening your web browser. See below for details. Note that the default IP address of the RPS-SP4L unit is 192.168.1.10 . If you place the remote power switch on your network and another computer/device has this IP address, you will not be able to access the RPS-SP4L unit. Please watch for this possible conflict.

1. Once the RPS-SP4L is powered and the network cable is connected, you will need to download the configuration program, RPS-SP4L-IPEDIT by clicking here. Start the rps-sp4l-ipedit.exe program. The initial screen is shown below.
   
   
   
   Click to Enlarge
   
   
2. The software will detect the RPS-SP4L unit. Click on the unit to highlight and you will be able to edit the Network configuration in the lower boxes. Click the CONFIGURE button to update the unit.
3. If you double click on the highlighted RPS-SP4L unit, your IE browser window will open and the web login screen will be shown. Alternatively, you can type the network address into IE in the form http://XXX.XXX.XXX.XXX Example: http://192.168.1.5 . Make sure the network cable is plugged into the RPS-SP4L unit and the master power switch is ON.The Default User Name is admin and the password is admin .

1. The Default IP Address of the RPS-SP4L is 192.168.1.10. You need to set your computer to the same subnet in order to access the remote power controller via a web browser. The same subnet means the first three parts of the IP Address of your computer, such as XXX.XXX.XXX.abc must be the same as the RPS-SP4L unit and the last grouping, the abc, must be different. An acceptable IP address for your computer would be 192.168.1.15, Netmask 255.255.255.0 and default gateway of 192.168.1.1. You typically need to go into your Start > Control Panel > Network Settings > Select a Network Port > Right Click > Select Properties > Click TCP/IP > which should open up a network configuration window. Please remember to write down your initial settings so you can return your computer to its present state.
2. Once your computer is on the same subnet as the RPS-SP4L unit, you can access the remote power switch by opening your IE browser and going to http://192.168.1.10 . A web login screen will be shown. Make sure the network cable is plugged into the RPS-SP4L unit and the master power switch is ON.The Default User Name is admin and the password is admin